@phdthesis{Schwindt2013,
  author    = {Schwindt, Daniel},
  title     = {Permafrost in ventilated talus slopes below the timberline - A multi-methodological study on the ground thermal regime and its impact on the temporal variability and spatial heterogeneity of permafrost at three sites in the Swiss Alps},
  url       = {http://nbn-resolving.de/urn:nbn:de:bvb:20-opus-90099},
  school      = {Universit{\"a}t W{\"u}rzburg},
  year      = {2013},
  abstract  = {In the central Alps permafrost can be expected above 2300 m a.s.l., at altitudes where mean annual air temperatures are below -1 °C. Isolated permafrost occurrences can be detected in north-exposed talus slopes, far below the timberline, where mean annual air temperatures are positive. Driving factors are assumed to be a low income of solar radiation, a thick organic layer with high insulation capacities as well as the thermally induced chimney effect. Aim of this study is to achieve a deeper understanding of the factors determining the site-specific thermal regime, as well as the spatially limited and temporally highly variable permafrost occurrences in vegetated talus slopes. Three supercooled talus slopes in the Swiss Alps were chosen for investigation. Substantially different characteristics were a central criterion in the selection of study sites. Located in the Upper Engadin, climatic conditions, altitude as well as dimensions of the talus slopes are comparable for the study sites Val Bever and Val Susauna; major differences are rooted in the nature of talus substrate and in humus- and vegetation distribution. Characteristics of the Br{\"u}eltobel site, located in the Appenzeller Alps, diverge with regard to climatic conditions, altitude and dimensions of the talus slope; humus- and vegetation compositions are comparable to the Val Susauna site. Confirmation and characterisation of ground ice is accomplished by the application of electrical resistivity and seismic refraction tomography. The estimation of the spatial permafrost distribution is based on quasi-3D resistivity imaging. For the confirmation of permafrost and the analysis of its temporal variability electrical resistivity monitoring arrays were constructed and installed at all study sites, to allow year-round measurements. In addition to resistivity monitoring, the - up to now - first seismic refraction tomography winter monitoring was conducted at the Val Susauna to analyse the permafrost evolution during the winter half-year. Investigations of the ground thermal regime were based on the analysis of temperature logger data. Besides recording air- and ground surface temperatures, focus was set on the temperature evolution in vents and in the organic layer. To analyse the relationship between permafrost distribution on the one hand and humus- and vegetation distribution on the other hand, an extensive mapping of humus characteristics and vegetation composition was conducted at Val Susauna. The existence of permafrost could be proven at all study sites. Spatially, permafrost bodies show a narrow transition to neighbouring, unfrozen areas. As observed at Val Susauna, the permafrost distribution strongly correlates with areas with exceptionally thick organic layer, high percentages of mosses and lichens in the undergrowth and dwarf grown trees. The temporal variability of permafrost has proven to be exceptionally high, with the magnitude of seasonal variations distinctly exceeding intra-annual changes. Thereby, the winter season is characterised by a significant supercooling. During snowmelt a growth in volumetric ice content is induced by refreezing of percolating meltwater on the supercooled talus. The results confirmed the fundamental influence of the chimney effect on the existence and temporal variability of permafrost in talus slopes. Divergences in the effectiveness of the thermal regime were detected between the study sites. These are based on differences in the nature of talus material, humus characteristics and vegetation composition. During summer, the organic material is usually dry at the daytime, inducing a high insulation capability and a protection of the subsurface against high atmospheric temperatures. Bouldery talus slopes typically show an organic layer that is fragmented by large boulders, which induces a strongly reduced insulation capability and allows an efficient heat exchange by convective airflow and percolating precipitation water. In the winter half-year, the thermal conductivity of the organic layer increases massively under moist or frozen conditions, allowing an efficient, conductive cooling of the talus material. The convective cooling in bouldery talus slopes affects an earlier onset and a higher magnitude of supercooling than under consistent humus conditions. Here, conductive heat flow is dominant and the cooling in autumn is buffered by a prolonged zero curtain. The snow cover has proven to be incapable of prohibiting an efficient supercooling of the talus slope in winter, almost independent from thickness.},
  subject      = {Engadin},
  language  = {en}
}
@article{SchwindtKneisel2011,
  author    = {Schwindt, Daniel and Kneisel, Christof},
  title     = {Optimisation of quasi-3D electrical resistivity imaging - application and inversion for investigating heterogeneous mountain permafrost},
  series = {The Cryosphere Discuss},
  volume    = {5},
  journal   = {The Cryosphere Discuss},
  doi       = {10.5194/tcd-5-3383-2011},
  url       = {http://nbn-resolving.de/urn:nbn:de:bvb:20-opus-138017},
  pages     = {3383-3421},
  year      = {2011},
  abstract  = {This study aimed to optimise the application, efficiency and interpretability of quasi-3D resistivity imaging for investigating the heterogeneous permafrost distribution at mountain sites by a systematic forward modelling approach. A three dimensional geocryologic model, representative for most mountain permafrost settings, was developed. Based on this geocryologic model quasi-3D models were generated by collating synthetic orthogonal 2D arrays, demonstrating the effects of array types and electrode spacing on resolution and interpretability of the inversion results. The effects of minimising the number of 2D arrays per quasi-3D grid were tested by enlarging the spacing between adjacent lines and by reducing the number of perpendicular tie lines with regard to model resolution and loss of information value. Synthetic and measured quasi-3D models were investigated with regard to the lateral and vertical resolution, reliability of inverted resistivity values, the possibility of a quantitative interpretation of resistivities and the response of the inversion process on the validity of quasi-3D models. Results show that setups using orthogonal 2D arrays with electrode spacings of 2 m and 3 m are capable of delineating lateral heterogeneity with high accuracy and also deliver reliable data on active layer thickness. Detection of permafrost thickness, especially if the permafrost base is close to the penetration depth of the setups, and the reliability of absolute resistivity values emerged to be a weakness of the method. Quasi-3D imaging has proven to be a promising tool for investigating permafrost in mountain environments especially for delineating the often small-scale permafrost heterogeneity, and therefore provides an enhanced possibility for aligning permafrost distribution with site specific surface properties and morphological settings.},
  language  = {en}
}