Refine
Has Fulltext
- yes (362)
Is part of the Bibliography
- yes (362)
Year of publication
Document Type
- Journal article (362) (remove)
Keywords
- Hadron-Hadron scattering (experiments) (29)
- Parton Distributions (25)
- ATLAS detector (18)
- Decay (15)
- proton-proton collision (15)
- Extension (14)
- physics (14)
- Higgs boson (13)
- ++ (11)
- High energy physics (11)
Institute
- Physikalisches Institut (362) (remove)
Sonstige beteiligte Institutionen
- Wilhelm-Conrad-Röntgen-Forschungszentrum für komplexe Materialsysteme (4)
- Röntgen Center for Complex Material Systems (RCCM), Am Hubland, 97074 W¨urzburg, Germany (2)
- Arizona State University, Tempe, Arizona, USA (1)
- Bavarian Center for Applied Energy Research (ZAE Bayern), 97074 Würzburg, Germany (1)
- Bavarian Center for Applied Energy Research e.V. (ZAE Bayern) (1)
- Fraunhofer-Institute for Applied Optics and Precision Engineering IOF Jena, Germany (1)
- Friedrich Schiller University Jena, Germany (1)
- Genelux Corporation, San Diego Science Center, 3030 Bunker Hill Street, Suite 310, San Diego, California 92109, USA (1)
- MRB Forschungszentrum für Magnet-Resonanz-Bayern e.V., Am Hubland, D-97074 Würzburg (1)
- Max Planck School of Photonics Jena, Germany (1)
The observed impurity induced far-infrared absorption in CsCl : Rb\(^+\) and CsCl : K\(^+\) is compared with a calculated density of acoustic phonon states in CsCl. The absorption due to CsCl : Rb\(^+\) displays a minimum between the acoustic and optic phonon bands. A narrow line is observed in CsCl: K\(^+\) at 85.8 cm\(^{-1}\) which falls in this quasi-phonon gap.
New resonant-mode infrared absorption lines have been observed in NaCl with high concentrations of fluorine impurities. The quadratic concentration dependence of the strength of these lines indicates that they are due to pairs of fluorine impurities. At the resonant frequencies, the motion of some host ions appears to be as important as the motion of the impurities themselves.
The preparation of Bi2Sea single crystals with low free carrier densities allowed an investigation of the lattice vibrations to be carried out from the reflectivity of cleavage planes at nearly normal incidence of the radiation (E ~ c). The experimental results ean be explained with two classical oscillators, whose eigenfrequencies oceur at 92 and 69.5 cm-I. The static dielectric constant was determined to be 100 ± 10 for E ~ c.
The photoconductivity of both undeformed and deformed Te samples has been investigated at liquid He temperature by means of a Fourier spectrometer. Three peaks were usually found in the spectra of undeformed samples at 11, 24 and 46 cm\(^{-1}\). These are shown to be due to three different chemical impurities. The deformed samples are characterized by additional structure at higher frequencies.
We have studied the lowest magnetic excitation of Ni\(_{1-x}\)Co\(_x\)O mixed crystals for 0.94 \(\leq\) x \(\leq\) 1. Together with previous results for 0.02 \(\leq\) x \(\leq\) 0.07 and neutron data for x = 0.14 and x = 0.30, the results are discussed by means of a model, especially the variation of AFMR frequency and preferred spin direction with Co concentration x.
We report here that reconstruction on (100), (1lIlA, and (1l1lB CdTe surfaces is either C(2X2), (2X2), and (l X I) or (2X I), (l X I), and (l X I) when they are Cd or Te stabilized, respectively. There is a mixed region between Cd and Te stabilization in which the reflected high-energy electron-diffraction (RHEED) patterns contain characteristics of both Cd- and Te-stabilized surfaces. We have also found that the Cd-to-Te ratio of the x-ray photoelectron intensities of their 3d\(_{3/ 2}\) core levels is about 20% larger for a Cd-stabilized (1lIlA, (1lIlB, or (100) CdTe surface than for a Te-stabilized one. According to a simple model calculation, which was normalized by means of the photoelectron intensity ratio of a Cd-stabilized (lll)A and aTe-stabilized (1l1lB CdTe surface, the experimental data for CdTe surfaces can be explained by a linear dependence of the photoelectron-intensity ratio on the fraction of Cd in the uppermost monatomic layer. This surface composition can be correlated with the surface structure, i.e., the corresponding RHEED patterns. This correlation can in turn be employed to determine Te and Cd evaporation rates. The Te reevaporation rate is increasingly slower for the Te-stabilized (Ill) A, (l1l)B, and (100) surfaces, while the opposite is true for Cd from Cd-stabilized (Ill) A and (Ill)B surfaces. In addition, Te is much more easily evaporated from all the investigated surfaces than is Cd, if the substrate is kept at normal molecular-beam-epitaxy growth temperatures ranging from 2oo·C to 300 ·C.
We report the results of a detailed investigation on the Te-stabilized (2 x 1) and the Cdstabilized c( 2 X 2) surfaces of ( 100) CdTe substrates. The investigation demonstrates for the first time that both laser illumination and, to a greater extent, high-energy electron irradiation increase the Te desorption and reduce the Cd desorption from ( 100) CdTe surfaces. Thus it is possible by choosing the proper growth temperature and photon or electron fluxes to change the surface reconstruction from the normally Te-stabilized to a Cd-stabilized phase.
We report the contactless determination of the conductivity, the mobility and the carrier concentration of II-VI semiconductors by means of the technique of the partially filled waveguide at a microwave frequency of 9 GHz. The samples are CdHgTe epitaxial layers, grown on CdZnTe substrates by molecular beam epitaxy. The conductivity is determined from the transmission coefficient of the sample in the partially filled waveguide. For the analysis of the experimental data, the complex transmission coefficient is calculated by a rigorous multi-mode matching procedure. By varying the conductivity of the sample, we obtain an optimum fit of the calculated data to the experimental results. Comparison with conductivity data determined by the van der Pauw method shows that our method allows to measure the conductivity with good accuracy. The behaviour of the transmission coefficient of the sample is discussed in dependence on the layer conductivity, the layer thickness and the dielectric constant of the substrate. The calculations require to consider in detail the distribution of the electromagnetic fields in the sample region. The usual assumption of a hardly disturbed TE\(_{10}\) mode cannot be used in our case. By applying a magnetic field in extraordinary Voigt configuration. galvanomagnetic measurements have been carried out which yield the mobility and thus the carrier concentration. These results are also in good agreement with van der Pauw transport measurements.
No abstract available
The microwave transmission and reßection is evaluated for stratified lossy dielectric segments partially filling the rectangular waveguide by the method which combines the multimode network theory with the rigorous mode matching procedure. As an example, we investigate in detail the microwave scattering properties of II-VI-epitaxial layer on a lossy dielectric substrate inserted in the rectangular waveguide. The experimental data verify the accuracy and the effectiveness of the present method. Extensive numerical results are presented to establish useful guidelines for the contactless microwave measurement of the conductivity of the epitaxiallayer.
The influence of different CdZnTe substrate treatments prior to II-VI molecular beam epitaxial growth on surface stoichiometry, oxygen, and carbon contamination has been studied using x-ray photoelectron spectroscopy and reflection high energy electron diffraction. Heating the substrate at 300 °C can eliminate oxygen contamination, but cannot completely remove carbon from the surface. Heating at higher temperatures decreases the carbon contamination only slightly, while increasing the Zn-Cd ratio on the surface considerably. The magnitude of the latter effect is surprising and is crucial when one is using lattice matched CdZnTe (Zn 4%) substrates.
We have grown HgTe/CdTe superlattices by molecular beam epitaxy; barrier thicknesses were in the range from 15 to 91 Å and the well thickness was maintained at a constant value of 30 Å. The infrared photoluminescence was investigated by means of Fourier transform infrared spectroscopy in the temperature range from 4.2 to 300 K. All superlattices showed pronounced photoluminescence at temperatures up to 300 K. To gain more detailed insight into the band structure of the HgTe/CdTe superlattices, band structure calculations were performed. The concept of the envelope function approximation was followed. Employing the transfer matrix method, the calculations were completed taking into account an eight band k·p model. An important parameter in these calculations is the natural valence band offset (VBO) between the well and barrier materials. As a general trend, the value for the direct gap decreases with increasing VBO. The experimentally determined energies of the band gap are in reasonable agreement with the values obtained by the theoretical calculations. A comparison between theory and experiment shows that the observed transition energies are closer to calculations employing a large offset (350 meV) as opposed to a small VBO (40 meV).
We have investigated Cd\(_{1-x}\)Mn\(_x\)Te thin films with Mn concentrations of x=0.12, 0.18, 0.30, 0.52, and 0.70. These single crystal layers were grown by molecular beam epitaxy on [001] CdTe substrates. The real part of the refractive index, n, was determined below the band-gap Eo in the range of 0.5-2.5 eV at T=300 K. The parallel reOectivity was measured near the Brewster angle at the YAG laser wavelength of 1.064 J.Lm (hv= 1.165 eV). Combining these results with the optical pathlength results (nd) of reOection measurements in a Fourier spectrometer we have determined n(x,v) over a wide spectral range by utilizing a three parameter fit. The accuracy of these results for n should improve waveguide designs based on this material.
No abstract available