Refine
Has Fulltext
- yes (3)
Is part of the Bibliography
- yes (3)
Document Type
- Doctoral Thesis (3)
Language
- English (3) (remove)
Keywords
- Raman Spektroskopie (3) (remove)
Institute
The enhancement of electronic and optical properties of semiconductor nanostructures is known as a direct consequence of the spatial confinement of carriers. However, the physics of quantum confinement is still not entirely understood. This work focuses on a qualitative study of quasi-zero dimensional II-VI semiconductor nanostructures (quantum dots QDs). In particular, commercially available as-received and heat treated CdSxSe1-x QDs embedded in a dielectric matrix were investigated by means of linear and nonlinear spectroscopy techniques. Low wavenumber Raman in off-resonance scattering regime was applied in order to obtain key-properties of the nanocrystals, such as the QD's size and the distribution of the QD's size inside the inhomogeneous broadening. Moreover, by careful selection of the polarization geometries, different acoustic vibrational modes could be evidenced. In comparison to the bulk, 3D confinement of carriers leads to modifications in the energy distribution in a QD and as a consequence, the intensity of the acoustical phonons is enhanced. However, only 2 acoustic vibrational modes (labelled l=0 and l=2) are Raman-active, which were selectively excited using linear polarized laser light in parallel- and cross-polarized excitation geometries. The QD's size was determined using the dependence of the frequency of the acoustic vibrational mode on the diameter of the vibrating particle, whereas the QD's size distribution was estimated from the normalized full width at the half of the maximum (FWHM) of the symmetric acoustic vibrational mode. In order to study relaxation mechanisms, which in quantum confined systems occur on a ps time scale, ultrafast spectroscopy techniques using laser pulses in the fs range must be employed. To this purpose, fs-FWM and fs-PPT measurements were performed on CdS0.6Se0.4 QDs of 9.1 nm in diameter, embedded in a glass matrix. The laser pulses employed in these experiments were circularly polarized, careful selection of the polarization geometries making different nonlinear processes available to study. It was shown that the relaxation of polarization selection rules depend strongly on the symmetry of the nanocrystals under discussion. The investigated nanocrystals belong to the symmetry group C2v or lower and their hexagonal crystal shape could be evidenced. The relaxation of selection rules was explained in the framework of the 4-level system, including a ground state, two exciton states and a biexcitons state. The appearance of FWM and PPT signals in forbidden polarization geometries was shown to be due to exciton state splitting due to lowering of the QD’s symmetry and due to the strong Coulomb interaction between carriers belonging to the same nanocrystal. Moreover, the significant difference in the origin of the gratings created by two pulses having the same and opposite polarizations, respectively. The intensity of the FWM signals should be the square of the intensity of the PPT signals and therefore the PPT measurements were employed as a check method for the results yielded by the FWM technique. The efficiency of circularly polarized femtosecond FWM spectroscopy techniques was proved once more in the investigation of heat treated CdSe QDs embedded in a dielectric matrix. The role of non-phonon energy relaxation mechanisms in the exciton ground and excited state of the QDs ensemble was extensively studied. Moreover, the dependence of the crystal shape asymmetry on the particle size and on the growth conditions could be estimated. It was shown, that the most efficient procedure to grow high quality nanocrystals is a longer heat treating at lower temperatures. In this case, the particles have more time to "nucleate" and to adopt a more "symmetric" shape. Further, the relaxation of excitons was extensively investigated. It was shown, that the electron intraband dynamics depend strongly on the Coulomb interaction between electrons and holes. Even at low excitation density, the Auger processes cannot be ignored. Auger autoionization of excitons followed by capture of carriers in surface states and deep traps in the dielectric matrix slow down the exciton relaxation process leading to an exciton lifetime ranging on a ps time scale. The relaxation of excitons from higher lying energy levels occurs also on two paths. At the beginning of the relaxation process (t31 < 400 fs), Auger-like thermalization of carriers is responsible for relaxation of the electron from 1pe into its 1se state, while the hole relaxes rapidly through its dense spectrum of states in the valence band. This process is immediately followed by capturing of carriers in deep traps, situated at the semiconductor-dielectric heterointerface. The traps are a consequence of the QD's asymmetry: the more and the deeper the traps, the higher the asymmetry of the nanocrystals (the band offset  is larger). This work presents a complete characterization of CdSSe QDs embedded in a glass matrix. The most important properties of the nanocrystals like QD's size and size distribution inside the inhomogeneous broadening were determined by means of low wavenumber Raman spectroscopy. In order to draw a full picture of these nanoparticles further complementary nonlinear spectroscopy techniques were used. Invaluable conclusions were available as a result of TI-FWM techniques applied in the framework of transient grating on 3D confined nanocrystals embedded in a glass matrix. The polarized the TI-FWM measurements were successfully performed on different QDs ensembles in order to determine symmetry properties and to describe the ultrafast relaxation mechanisms. This work brings additional contribution concerning the preparation of high quality QDs by presenting the effect of different growth conditions on the QDs symmetry, thus indicating a way for efficient manufacturing of nanocrystals.
This thesis is concerned with the development of an on-line in-situ device for a chemical characterisation of flowing aerosols. The thesis describes the principles and most important features of such a system, allowing also on-line measurements using Raman spectroscopy as a diagnostic technique An analysis of the effect of forced oscillations on the motion of the particle dispersed in a gas flow is given in Chapter 2. Also the most important particle parameters are introduced. A review of the particle/fluid interaction in laminar air flows and the response of the particle is presented. In Chapter 3 the behaviour of the particle under different external conditions (ion bombardment and electric fields) is extended. A brief review of the most important particle charging theories (diffusion, field, and alternating potential charging) shows, that the effect of the electrical properties (represented by the dielectric constant) of the particles affects the charging process. A non-contact method for particle charge measurement was also presented. In the second part of the chapter, the interaction between the electric field and the charged particle for the purpose of particle trapping is illustrated. The most common systems like the two or four ring electrodynamic balance and the quadrupole trap are pointed out. In Chapter 4 a short review of the possibility of using scattered light to study aerosol particles is presented. First, the conditions and the facilities of using the Mie theory for particle size and refractive index determination are mentioned, then some features concerning the classical treatment of the Raman effect are presented Supported by the theoretical considerations exposed in Chapter 2, 3, and 4 the construction and the tests of different devices are presented in Chapter 5. Following the goal of the thesis, first an overview of the used materials and methods for particle generation is presented. Then, the constructed charging devices are described (from the mechanical and electrical point of view) and compared by measuring the acquired charge on the particle. Charged particles can be trapped in different containers. Two types of axially symmetric electrodynamic balances (two ring or an extended four ring configuration) were presented. For a deeper understanding these systems were studied using analytic and numerical methods. Considering the presented purpose of the work another type of trapping system has been developed, namely the quadrupole trap. A similar theoretical characterisation (in term’s of Mathieu equation) as for the electrodynamic balance was presented pointing out some specific features of this system. The incoming particle stream will be focused to the centre of the system simultaneously also the applied DC and AC potential onto the tube electrodes, yields a stable trapping of one or more particles. Chapter 6 consists of two parts: the system for single particle and for many particles investigation. The individual devices presented in Chapter 5 are now put together. The first part presents the method and the experimental realisation of a set-up for solid particle injection. In order to suppress the phase injection disadvantage found for the electrodynamic balance a developed program processes the information obtained from a particle cloud through an adequate electronic detection system, and reduces the number of particles until just one single particle is trapped. The method for one particle investigation can be extended for many particles. Using the presented set-up the particles are moved from one quadrupole to another and transformed from a particle cloud to a particle stream. A linearity between an external vertical mounted detector and the formed image of the particle stream on the CCD camera has been observed and used for simultaneous detection of many particles by Raman spectroscopy. For both methods Raman results are presented. One limitation of Raman Spectroscopy is the relatively long integration time needed for adequate signal-to-noise ratio. There are two factors which influence the integration time: first the incident radiation and the detector sensitivity, and second the intensity of the Raman bands. Using a CCD detector, the desired detector sensitivity should be achieved. So, the improvement of the signal-to-noise ratio should be the next goal in the system development. In order to reduce the integration time an optical system including optic fibres and the integration of an FT-Raman module operating in the visible region is planed. The goal of this work was to develop and construct an instrument for on-line in-situ single particle investigation by Raman spectroscopy. With the presented experimental set-up and the developed program the purpose of the work, the on-line in-situ near atmospheric pressure aerosol investigation was achieved. The Raman spectroscopy has been used successfully for a chemical characterisation of the aerosol particles.
The present work consist of two major parts. The first part, extending over chapters 1, 2, 3 and 4, addresses the design and construction of a device capable of determining the shell thickness and the core size for monolayer spherical particles in a flow. The second part containing chapters 5, 6, 7, 8, 9 and 10, concentrate on the use of Raman spectroscopy as a space application, namely for use as a tool for in situ planetary investigations. This part directly addresses the MIRAS project, a study run under the auspices of Federal Ministry of Education and Research, BMBF and German Aerospace Center, DLR under national registration number 50OW0103. MIRAS stands for "Mineral Investigation by in situ Raman Spectroscopy". Microcapsule Sizing by Elastic Light Scattering The industrial development of processes based on microcapsules depends on the possibility to provide clear and complete information about the properties of these microcapsules. However, the tools for an easy and efficient determination of the microcapsule properties are lacking, several methods being often required to describe adequately the microcapsule behavior. Methods for evaluating the individual size and size distribution of both the core and the shell are required together with methods for measuring the mechanical strength, stability in appli-cation media, permeability of the shell, etc. Elastic light scattering measurements provide a possible way of determining properties such as core size, shell size and refractive index. The design and con-struction of a device capable of measuring the above mentioned parameters for a core-shell particle is the subject of the first part of this thesis. The basic principle of measurement for the device proposed here consists of an-alyzing one particle at a time by recording the elastic light scattering pattern at angles between approx. 60 and 120 grad. By comparing the experimentally recorded phase functions with the previously calculated phase functions stored in a database, the geometry of the scattering object can be identified. In our case the geometry is characterized by two parameters: the shell thickness and the core radius. In chapter 2 a short overview on the methods used for sizing microparticles is given. Different sizing methods are compared, and the advantages and disadvan-tages for the general problem of sizing are shortly discussed. It is observed that all sizing methods that are based on elastic light scattering theories are ensemble methods. Chapter 3 focusses on the theories used for calculating the theoretical scattering patterns with emphasize on the Mie theory. The generalization of Mie theory for layered particles is shortly presented and the far field intensity approximations are discussed. The last chapter (4) of this first part describes the experimental approach for building an automatic microcapsule sizer. The approach started by O. Sbanski [76] with the development of a software packet for calculating and storing theoret-ical phase functions for core-shell particles was continued with the designing and construction of a measuring device. The hardware construction and the software with all implemented corrections imposed by the individual setup components are described in detail. For the laser, the monochromaticity, the intensity profile of the beam as well as the planarity of the equi-phase fronts are taken into consid-eration. The flow cell with three different designs is described, and the influences of the employed design on the light scattering patterns are discussed together with the optical system used for recording the experimental phase functions. The detection system formed by two identical linear CCD arrays is presented together with the software approach used for data acquisition. Ways of improving the quality and the speed of the analyzing process are discussed. The final section presents measurements run on samples made of homogeneous spheres and also on samples containing industrial microcapsules. Mineral Investigation by in situ Raman Spectroscopy The envisaged future planetary missions require space-born instruments, which are highly miniaturized with respect to volume and mass and which have low needs of power. A micro Raman spectrometer as a stand alone device on a planetary surface (e.g. Mars) offers a wide spectrum of possibilities. It can assess the chemical analysis via determination of the mineral composition, detect organic molecules in the soil, identify the principal mineral phases, etc. The technical developments in the last years have introduced a new generation of small Raman systems suitable for robotic mineral characterization on planetary surfaces [20, 95]. Two different types of spectrometer were considered for the MIRAS study. As supporting laboratory experiments for the MIRAS study, the measure-ments on standard minerals and on SNC Mars meteorites are discussed in chapter 6. The following SNC meteorites have been investigated: Sayh al Uhaymir 060, Dar al Gani 735, Dar al Gani 476, Northwest Africa 856, Los Angeles, Northwest Africa 1068 and Zagami. Pyrite as a hitherto undescribed phase in the picritic (olivin-phyric) shergottite NWA 1068 as well as reduced carbon (e.g. graphite) and anatase in the shergottite Say al Uhaymir 060 are new findings for this class of meteorites. A detailed description of the proposed designs for MIRAS, with the compo-nents used for building the test version on a breadboard is covered in chapter 7. The scientific as well as the mission requirements imposed on the instrument are discussed. The basic design is presented and the main components that are brought together to build the device being the laser unit, the Raman head, the Rayleigh filtering box, and the spectral sensor (spectrometer with a matching de-tector) are described. The two proposed designs, one based on an acousto-optic tunable filter (AOTF) and the other based on a dispersive hadamard transform spectrometer are compared to each other. The actual breadboard setup with the detailed description of the components follows in Section 7.3. Further de-velopment of a Raman spectrometer for planetary investigations is proposed in combination with a microscope as part of the Extended-MIRAS project. The software developed for controlling the breadboard version of MIRAS is described in chapter 8 together with a short description of the structure of a relational database used for in house spectra management. The measuring pro-cedures and the data processing steps are presented. Spectra acquired with the MIRAS breadboard version based on the AOTF are shown in chapter 9. The final chapter addresses a rather different possibility of using Raman spectroscopy for planetary investigations. The chapter summarizes the content of four tech-nical notes that were established within the study contracted by the European Space Agency with firma Kayser-Threde in Munich concerning the possibility of applying Raman spectroscopy in the field of remote imaging.