Refine
Has Fulltext
- yes (3)
Is part of the Bibliography
- yes (3)
Document Type
- Doctoral Thesis (3)
Keywords
- permeation (3) (remove)
The seed coat is the barrier controlling exchange of solutes between the plant embryo and its environment. This exchange is of importance for example in the uptake of germination inhibitors or in the uptake of agrochemicals applied as seed treatment. A thorough understanding of the basic mechanisms underlying solute permeation across the seed coat would help to improve the effectiveness of seed treatment formulations. In seed treatment formulations, additives can be used to enhance or decrease mobility or uptake of the active ingredient (AI). In the present study the seed coat barrier properties and the seed coat permeation process was examined with the model species Pisum sativum and with a set of model solutes. The lipophilic fraction of the seed coat was analysed by gas chromatography and mass spectrometry and it was found that the total lipophilic compartment of the seed coat represents 0.61 % of the weight of a swollen seed coat. The seed is covered by a lipophilic cuticle. The seed coat coverage with cuticular waxes is ten to 18-fold lower than wax coverage of pea leaves, though. In order to examine sorption of solutes in the small lipophilic compartment of the seed coat, seed coat/water partition coefficients were determined. These cover a much smaller range than the corresponding n-octanol/water partition coefficients. The lipophilic sorption compartment as calculated from the seed coat/water partition coefficient data is smaller than the analysed total lipophilic compartment of the seed coat since not all of the lipid components can act as sorption compartment. During seed swelling, the pea seed nearly doubles its weight. The uptake of water is driven by the very low water potential of the dry seed and controlled by the seed coat hydraulic conductivity both of which increase during seed swelling. Depending on the available form of water, water uptake can take place by diffusion from air humidity or by mass flow from liquid water. Water uptake by a seed in moist sand takes place by a combination of both uptake mechanisms. The basic transport mechanism underlying solute permeation of seed coats was analysed by steady-state experiments with a newly devised experimental setup. The permeance P for permeation of the set of model compounds across isolated seed coat halves ranged from 3.34 x 10-8 m s-1 for abamectin to 18.9 x 10-8 m s-1 for caffeine. It was found that solute permeation across the seed coat takes aqueous pathways. This was concluded from the facts that molar volume instead of lipophilicity of the solutes determine permeation and that the temperature effect on permeation is very small. This is in contrast to typical leaf and fruit cuticular uptake where lipophilic pathways dominate. Solute uptake across the seed coat can take place by two different mechanisms both of which take aqueous pathways. Uptake can be by diffusion and in the presence of a bulk flow of water driven by a water potential difference also by solvent drag. The presence of the solvent drag uptake mechanism shows that the aqueous pathways form an aqueous continuum across the seed coat. These findings indicate that the seed coat covering cuticle does not form a continuous barrier enclosing the seed. In order to examine solute uptake across the seed coat under conditions close to a situation taking place in the field, the process of uptake of a seed treatment AI in the field was simulated. In the situation of a treated seed in the field, the seed treatment residue dissolves and then the AI can move either into the surrounding soil or across the seed coat into the seed. Uptake across the seed coat can take place either by diffusion or during seed swelling by the solvent drag mechanism. Since the seed treatment residue depletes over time, non-steady-state uptake takes place. To simulate these processes, laboratory scale seed treatment methods were established to produce treated seeds and isolated treated seed coat halves. Experimental setups for non-steady-state uptake experiments were established with whole treated seeds and with isolated treated seed coat halves as simplified screening tool. By modelling of the AI uptake as a first-order process the rate constant k and the final relative uptake amount Mt→∞ M0-1 were obtained. With k and Mt→∞ M0-1 a quantification and comparison of the uptake curves was possible. Both in the experiments with whole treated seeds and with isolated treated seed coats, uptake of metalaxyl-M was much faster than uptake of sedaxane. In the uptake of a seed treatment AI, not only the solute's molar volume but also its water solubility determine uptake. The solute's water solubility is important for dissolution of the AI from the seed treatment residue and thus determines availability of the AI for uptake. Water solubility also controls the possible concentration in solution and thus the driving force for diffusive uptake. Furthermore, the AI amount taken up by solvent drag is determined by concentration in the inflowing water and thus by water solubility. In the experiments with whole treated seeds the additive effects on uptake were smaller than in the experiments with isolated treated seed coats or not significant. Adigor functions as an emulsifier and can lead to a slight increase of AI mobilisation from the seed treatment residue. NeoCryl A-2099 can cause a slowed down release of the AI from the seed treatment residue. The effects of both additives were smaller than the effect caused by different AI physico-chemical properties. Therefore, the most important factor determining uptake of a seed treatment AI are the AI's physico-chemical properties, especially its water solubility.
Quellfähige natürliche Schichtsilicate können nach vorheriger Modifizierung als nanoskalige Barrierefüllstoffe für hybridpolymere Beschichtungen eingesetzt werden. Durch Ionenaustausch nach der „Onium-Methode“ wurden aus natürlichem Montmorillonit unterschiedlich modifizierte organophile Schichtsilicate hergestellt, die mit thermisch oder strahlenhärtenden Barrierelacken verträglich sind. Als Modifizierungsreagenzien kamen neben aliphatischen auch olefinische und alkoxysilylfunktionelle Ammonium-Verbindungen zum Einsatz. Beschichtungen aus den modifizierten Barrierelacken zeigten teilweise deutlich verbesserte Sauerstoffbarriereeigenschaften. Ein signifikanter Einfluß auf die Wasserdampfbarriere war bei diesem Füllstoffanteil nicht festellbar. Die optische Transparenz der hybridpolymeren Barriereschichten wird auch durch Anteile von bis zu 5 Gew. % an Schichtsilicat nicht nennenswert beeinflusst. Dies belegen UV-VIS-Spektren.Aufgrund der deutlichen Steigerung der Sauerstoffbarrierewirkung unter Beibehaltung der optischen Transparenz der Beschichtung stellt die Kombination von modifizierten Schichtsilicaten mit hybridpolymeren Barrierelacken daher eine interessante Alternative zu den bisher eingesetzten Barrieresystemen ohne Füllstoff dar. Der Einfluss von Lacklagerung, Lackkomponenten und Härtungsbedingungen im Hinblick auf die Struktur und Sperrwirkung von Hybridpolymerschichten wurde im zweiten Teil dieser Arbeit untersucht. Dabei wurden die Ergebnisse struktureller Untersuchungen durch 29Si, 13C- und 27Al-NMR-Spektroskopie mit Barrieremessungen korreliert. Der letzte Teil der Arbeit befasst sich mit der Optimierung von Migrationsschutzschichten. Hybridpolymere bieten neben einer Barrierewirkung gegenüber Gasen und Dämpfen auch einen wirksamen Schutz gegen die Migration weiterer chemischer Substanzen, wie z.B. Weichmachern. Am Beispiel eines strahlenhärtenden hybridpolymeren Lackes wurde über die Formulierung des Lackes eine Korrelation zwischen Migrations- und Sauerstoffbarrierewirkung hergestellt.
Permeationseigenschaften von Polydimethylsiloxan-Membranen in Abhängigkeit von der Netzbogenlänge
(2002)
Für die definierte und konstante Wirkstofffreigabe aus therapeutischen Systemen sind Kenntnisse der Mikrostruktur vonKontrollmembranen von großer Bedeutung. Durch eine Additionsreaktion können Polydimethylsiloxan-Membranen ausvinylendgestoppten linearen Polydimethylsiloxanen und niedermolekularen Si-H-funktionalisierten Polydimethylsiloxanen unterEinfluss eines Platin- Katalysators hergestellt werden. Hierbei ist es durch den Einsatz genau charakterisierterAusgangspolymere möglich, Membranen mit einer statistisch definierten Mikrostruktur zu erhalten. Die Mikrostruktur kanndurch die Netzbogenlänge charakterisiert werden. Der Abschnitt zwischen zwei Verknüpfungspunkten in einem Netzwerk wirdals Netzbogenlänge (NBL) bezeichnet. Diese beschreibt die Anzahl der Dimethyl-siloxan-Einheiten zwischen zweiVerknüpfungen. Die Permeationseigenschaften wurden mit Hilfe des standardisierten Permeationskoeffizienten untersucht. Derstandardisierte Permeationskoeffizient ist von der mittleren Netzbogenlänge der Polydimethylsiloxan-Membranen abhängig. Dieser Zusammenhang wurde an elf Benzoesäure- und Naphthalinderivaten als Modellsubstanzen untersucht und bestätigt.Hierbei wurden Membranen mit den mittleren Netzbogenlängen 65, 99 und 122 Siloxan-Einheiten für die Untersuchungeneingesetzt. Bei allen untersuchten Substanzen stieg der Permeationskoeffizient mit größer werdender Netzbogenlänge derMembranen geringfügig an. Die Permeationskoeffizienten von Membranen mit der Netzbogenlänge 122 waren dabei - mitlediglich vier Ausnahmen - stets statistisch signifikant größer als von Membranen mit der Netzbogenlänge 65. Als mögliche weitere Einflussfaktoren auf die Permeationsgeschwindigkeit wurden der Membran/Wasser-Verteilungskoeffizient, dasDipolmoment und das van der Waals-Volumen der elf Modellsubstanzen untersucht. Es konnte ein Zusammenhang zwischendem Membran/Wasser-Verteilungskoeffizienten und dem Permeationskoeffizienten aufgezeigt werden. Das Volumen deruntersuchten permeierenden Moleküle hat jedoch nur bei Netzbogenlängen kleiner als 122 einen Einfluss auf diePermeationsgeschwindigkeit. Als neue Möglichkeit zur Untersuchung der Diffusionskinetik vor Erreichen des stationärenZustands in Polydimethylsiloxan-Membranen wurde die konfokale Raman-Spektroskopie eingesetzt. Bei derRaman-Spektroskopie wird das Probensystem während der Messung weder zerstört noch verändert. Weiterhin ist es möglich,durch das gekoppelte konfokale Mikroskop gezielt an einem bestimmten Punkt innerhalb der Membran zu messen. Damitkönnen nun dynamische Vorgänge wie der Aufbau eines Konzentrationsgradienten vor Erreichen des stationären Zustandes aneinem bestimmten Punkt in einer Membran über einen längeren Zeitraum gemessen werden. Anhand von Intensitätsänderungencharakteristischer Peaks oder der Verschiebung von Banden werden Konzentrations- und Strukturänderungen der Membranund der permeierenden Moleküle sichtbar. Die Untersuchungen mit der konfokalen Raman-Spektroskopie zeigten, dass dieseMethode geeignet ist, Diffusionskinetiken im nicht stationären Zustand innerhalb der Membranen zu beobachten.