Refine
Has Fulltext
- yes (21)
Is part of the Bibliography
- yes (21)
Document Type
- Journal article (20)
- Conference Proceeding (1)
Language
- English (21)
Keywords
- Festkörperphysik (1)
- Physik (1)
Institute
In this paper, we present results on the first MBE growth of HgSe. The influence of the GaAs substrate temperature as well as the Hg and Se fluxes on the growth and the electrical properties has been investigated. It has been found that the growth rate is very low at substrate temperatures above 120°C. At 120°C and at lower temperatures, the growth rate is appreciably higher. The sticking coefficient of Se seems to depend inversely on the Hg/Se flux ratio. Epitaxial growth could be maintained at 70°C with Hg/Se flux ratios between lOO and ISO, and at 160°C between 280 and 450. The electron mobilities of these HgSe epilayers at room temperature decrease from a maximum value of 8.2 x 10^3 cm2 /V' s with increasing electron concentration. The concentration was found to be between 6xlO^17 and 1.6x10^19 cm- 3 at room temperature. Rocking curves from X-ray diffraction measurements of the better epilayers have a full width at half maximum of 5S0 arc sec.
We report on the growth of the compound semiconductor MgTe as weil as the ternary alloy Cd\(_{l-x}\)Mg, Te by molecular hcam cpitaxy. This is to our knowkdgc thc first time that this material has heen grown by any epitaxial technique. Bulk MgTe, which is hygroscopic, has a band gap of 3.0 eV and crystallizcs usually in thc wurtzite structure. Pseudomorphic films were grown on zincblende Cd Te suhstrates for a MgTe thickness helow a critical layer thickncss of approximately 500 nm. In addition, Cd\(_{l_x}\),Mg\(_x\)Te epilayers were grown with a Mg concentration between 0 and 68%, which corresponds to a band gap betwcen 1.5 and 2.5 eV at room temperature. The crystalline quality of thc layers is comparabk to CdTc thin films as long as they are fully strained. The lauice constant of zincblende MgTe is slightly smaller than that of CdTe, and the lattice mismatch is as low as O.7%. In addition highly n-type CdMgTe layers were fabricatcd by hromine doping. The tunability of the band gap as weil as the rather good laUice match with CdTc makes the matcrial interesting for optoelectronic device applications for the entire visible range.
A semiempirical model is presented that correlates the broadening of the absorption edge with both transitions below the energy gap and with transitions by the Kane band model. This model correctly fits both the absorption and luminescence spectra of narrow-gap (Hg,Cd)Te samples that have been grown by the traveling heater method as well as by molecular-beam epitaxy. The accuracy of the band-gap determination is enhanced by this model.
The influence of different CdZnTe substrate treatments prior to II-VI molecular beam epitaxial growth on surface stoichiometry, oxygen, and carbon contamination has been studied using x-ray photoelectron spectroscopy and reflection high energy electron diffraction. Heating the substrate at 300 °C can eliminate oxygen contamination, but cannot completely remove carbon from the surface. Heating at higher temperatures decreases the carbon contamination only slightly, while increasing the Zn-Cd ratio on the surface considerably. The magnitude of the latter effect is surprising and is crucial when one is using lattice matched CdZnTe (Zn 4%) substrates.
The surface sublimation of Cd and Te atoms from the zinc blende (111)A CdTe surface has been investigated in detail by reflection high energy electron diffraction and x-ray photoelectron spectroscopy. These experiments verify that Te is much easier to evaporate than Cd. The experimental value for the Te activation energy from a Te stabilized (111)A CdTe surface is 1.41 ±0.1O eV, which is apparently inconsistent with recent theoretical results.